Installing Garage Door Opener Off Center

The only consideration is the door is balanced properly on spring tension.

Installing garage door opener off center.

Use one piece as near to the top as you can which would be. Prepare your garage door for opener installation. The weight of a garage door is supported by the door springs cables and pulleys not the opener. An opener will work ok off center of the door but really needs to be perpendicular to the door.

The garage door opener mounting bracket also called the header bracket secures the carriage tube to the wall above the door. As you said run perforated angle iron from the center stile to the next stile over. If you can t raise and lower the door normally by hand do not install the opener until the door is repaired. Request service online in store or by phone and a licensed professional installer will contact you to schedule the installation date.

Move the obstruction rather than do the installation off center. Whether for the purchase installation maintenance replacement or repair of your garage door or 28. Follow the manufacturer s instructions to assemble the opener and mount the rail to the header bracket above the door. Make sure your garage door is well lubricated and operating properly.

If your door has extension springs the opener must be installed in the center of the door. Garage door opener installation is available starting at 127 including removal and haul away of old openers and other materials. To offset mount the opener arm to the door section. Lift the power unit.

Then set the opener on a ladder where you re going to install it. It is common for people to try to install it off center because of obstructions. Midway garage doors is your garage door and opener expert. Place the opener on a ladder and use scrap lumber to get it at the height you need.

Failure to do so will cause the door to buckle and bind. Align the opener s rail with the center of the garage door. The opener can be installed within 4 feet to the left or right of the door center if there is a torsion spring or center bearing plate in the way of the header bracket or door bracket area. The exact location depends on the type of door.