Installing Genie Garage Door Opener Safety Sensors

Similarly the genie brand is owned by overhead door so genie s safe t beam sensor also on amazon is the same sensor used for both genie and overhead door garage door openers.

Installing genie garage door opener safety sensors.

You can use this video for other genie garage door openers that use the same tube rail that are belt or chain models as well. Fasten to header and wall preferably with insulated staples. Genies safe t beam system is designed to ensure maximum safety for your garage door opener operation. Either wire to either terminal non polar.

At source and sensor route wires through bracket as shown and attach wires at terminals. Replace with the new genie garage door sensors. The convenient video features step by step directions for installing genie garage door opener models 2055 and 7055. 1 push the safety sensor with attached carriage bolt.

Installing the sensors as part of the garage door opener installation requires attention to wiring and adjustments to the devices themselves. If this was not available and did not accept a gdo safety beam sensor it is trivial to control the opener with an arduino and end stop switch to let the arduino know that the garage door is in the down position and a relay to trigger the door open close. However genie uses clips to secure the wires to the opener rail rather than stapling the wires to the ceiling. These comes with the wall attachment already on.

Hook the wires under the flat square and tighten. Allow for some slack at the source and sensor units and cut off any excess wire. So if you upgraded your overhead door garage door opener to a genie opener then you are in luck. First attach the wires to the screws on the side of the sensor by gently loosening the screws.

Step 1 unroll the low voltage wires on each side of the door from the sensor back toward the genie power head.