Nail up the large base photo 13.
Installing trim around sliding glass door.
Use expanding foam insulation to seal any gaps between the door frame and wall.
Measure the lip of the threshold s trim and leave enough clearance between the door and the flooring to install the threshold.
Replacing sliding glass doors.
Make sure the screws aren t exposed.
Trim with a 1 8 inch gap after the flooring has been laid.
Cover the foam insulation with trim and add a small amount of caulk to the visible joint.
Cut all the base extra long rough cut all the baseboards about 2 in.
Step 3 install.
Use a putty knife to remove the excess.
Nail the cap and shoe.
Secure the first piece with your carpentry nails.
Replacing sliding glass doors.
Part of the series.
Secure the threshold to the door with screws.
Make use of various t molds that are available for your laminate here.
In either case once you re ready to begin choose a side of the door to begin with and start lining the molding up in the exact spots you measured and marked earlier.