Plan the installation to start at a left side corner and work outward across the wall to the right.
Installing white hardboard wall panel.
Insert 3 4 inch nails through the stud spacing them every 8 inches.
After attaching the panel to the center stud insert additional nails through all remaining studs in the same manner.
Who says you can t draw on the walls.
Place the first hardboard panel up to the corner of the wall and locate a wall stud in the center of it.
The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.
For best results set the paneling in the room for a few days before you install it.
Tack a full panel in place with one long edge aligned with the plumb mark then check to see how the opposite edge fits into the corner.
It is not intended for use in a high moisture area like a shower or bathtub surround.
From an inside corner on a wall where you wish to start installing 4 foot wide panels.
For other options like our thrifty white smooth paneling you can quickly brighten up utility and laundry rooms.
Step 1 move the hardboard panels into the installation room and lean them up against the wall with the backs facing outward toward the room.
When installing hardboard on the ceiling secure it firmly to the joists to prevent sagging.
This is the.
If the corner isn t straight and plumb you ll see gaps.
Thick x 4 ft.
How to install tempered hardboard panels to walls.
Panel should end and begin on a stud.
This will allow it to adjust to the humidity in a room.
Measure mark and cut the beadboard.
Panel joints may be caulked with pure white silicone sealant and panel edges fitted into extruded plastic moldings.
With our markerboard and frost white panels you can add a functional wall to draw and color on such as in workshops and playrooms.
Leave the panels in this location for a minimum of 48 hours before installation to allow them to acclimate.
In a conventionally framed room with wall studs 16 on center each 4x8 ft.
Installation is done using a high grade panel or construction trowel on adhesive.
Using a level mark a plumb line 48 in.
Gently remove any crown moulding baseboards and trim you plan on using again.
Measure the height of the wall where you plan to install the hardboard panels using a tape measure.