The key to successfully insulating basement walls is selecting insulating materials that stop moisture movement and prevent mold growth.
Insulation against concrete walls basement.
Any of the following insulation materials are acceptable for this purpose.
Notice the difference between the studs against the foundation and the studs that formed an interior division wall.
Adding insulation will keep your basement warmer make the floors above warmer and more comfortable plus it will lower heating bills.
This was a typical basement wall assembly with a stud wall directly against the foundation followed by fiberglass insulation and a vapour barrier.
Concrete stone concrete block and other masonry foundation materials have very little insulating value a foundation wall can account for approximately 20 of heat loss.
Closed cell spray foam is the best way to insulate concrete basement walls.
It can fill in all the gaps and spaces thoroughly giving you the best protection against moisture and air infiltration.
When insulating concrete basement walls a good idea because concrete basement walls are often cold use rigid foam board insulation if the insulation will come into direct contact with the.
David caruso springfield pa.
I am about to put in the insulation and my contractor has recommended pink fibreglass batts between the studs leaving an air gap between the pink and the vapour barrier on the concrete.
This is because it can achieve a higher r value along with excellent moisture resistance with less thickness required.
That is if the studs are going to touch the concrete wall.
Or you can leave a 4 inch gap between the studs and concrete wall and probably get away with it.
How do i insulate walls with stud bays only 1 inches thick.
And there is no effective way to fill the voids in an existing concrete block wall.
Closed cell spray polyurethane foam or either xps eps or polyisocyanurate rigid foam.
The best way to insulate the interior side of a basement wall is with foam insulation that is adhered to or sprayed directly on the concrete.
The vapour barrier did not protect the exterior wall from damage and mold growth.
I have a 1950s brick colonial with uninsulated concrete block walls.
Inside the drywall is nailed to studs fastened flat against the block.
So you must assume that your concrete is fully saturated and full of water in order to properly insulate your basement walls.
Insulation materials are the key.
This will allow you to cut your batts to fit comfortably between them.
Space your studs either 16 or 24 apart.
Most jurisdictions require a 4 mil plastic sheet vapor barrier for basement walls against concrete.