Interior Door Lever Lock Put Back Togethr

If you spray a little wd 40 on the interior of the lock before putting it back together you ll have a nice and quiet lock as perfectly operational as the day its first owner bought it.

Interior door lever lock put back togethr.

Slide the inside housing into place. The only thing left is to install it on the door and claim your prize as a restorationist no cash value. The distance between the edge of the door and the center of the lock hole. Usually the backset measures 2 3 8 inches or 2 3 4 inches.

Once triggered the lever or lock trim can be removed from the door. If you re installing a lever orient the lever just as you did with the outside housing pointing away from the edge of the door. The interior side of the door lever has the thumb lock in the center of the lever the. Drill the screws carefully being sure to keep your drill level with the floor.

Latch does not have its own screws but uses the thru bolts to hold it in place under the inside handle when it is put back together. Choose the right lock to fit your door before purchasing a lock measure your door s backset cross bore and thickness to ensure you find the right fit. If the new latch plate is bigger than the old one cut a mark around the edge of the plate s edge using the utility knife. Once these thru bolts which clamshell the inner and outer handles are removed inner handle should pop off and latch sits behind it in a plastic cavity.

The flat surface of the latch should be on the interior side of the door. If any screws are exposed during this process remove them to release the lock and remove it from the door. Be careful to fit the latch into the chiselled area and screw into the pilot holes that were made earlier. When repairing or replacing a doorknob lever you need to remove the faceplate also called a trim plate or rosette to gain access to the.

Straighten a paper clip and insert it into the hole. Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Normally 1 2 inch is sufficient. How to remove the faceplate from a lever door knob.

Install the interior side of the door lever into the doorknob hole and through the openings in the latch. On a standard pre drilled door you ll be done installing your passage lock in just minutes using only a tape measure and a phillips screwdriver. Then trim using utility knife. If the new latch mechanism is longer than the old one drill about 1 2 inch in.

Use this video to check that your door is properly prepared. 7 with the screw holes in a vertical position align the square in the back of the door knob or lever with the square spindle.